Centrum Drawings

Generate Drawings for: Denmark

Centrum pile cross-section

Special reinforcement type

Helical pitch

0 mm

Helical height

0 mm

Here can you choose the possible countries.

Choose the country for generating a drawing.

Concrete

CPG K2

CPG K4

CPG K6

CPG K8

CPD-joint

Crackring

Please select PileEndTop

Concrete

CPG K2

CPG K4

CPG K6

CPG K8

CPD-joint

Point

Rock point 50

Rock point 60

Rock point 70

Box shoe

Crackring

Concrete/wood-joint

Please select PileEndBottom

reCAPTCHA thinks that you are a robot. If you do not agree, then try again.

We draw attention to the fact that there is NO automatic correlation between the drawing program Centrum Drawings and the calculation program Centrum Pile Calculator. Drawings and calculations must therefore be configured separately. Centrum Drawing only reflects the possible configurations of piles that can be produced at Centrum Pæle A/S. Centrum Pæle A/S assumes no responsibility for whether the configuration and/or drawing meets project and/or standard-specific requirements.

Centrum Pile Select will not save a copy of the generated report or any of the typed information.
The static structural bearing capacity of a selected pile element in selected calculation conditions is calculated. Be aware that important pile analyses, such as driveability and geotechnical bearing capacity, are not taken into account. These must be considered separately.

CENTRUM PÆLE END USER LICENSE AGREEMENT FOR CALCULATION AND DRAWING SOFTWARE

IMPORTANT-READ CAREFULLY: This End User License Agreement (the "Agreement") for use of the calculation and drawing programme and any information on centrumpileselect.com (collectively the "Software") constitutes a valid and binding agreement between you (being either an individual or an entity) and Centrum Pæle A/S, company registration number (CVR) 27242561, Grønlandsvej 96, 7100 Vejle, Denmark ("Centrum Pæle"). The Software includes any documentation and any updates and upgrades that Centrum Pæle may make available to you during the term of this Agreement. You must accept this Agreement in order to use the Software in accordance with the terms set forth herein.

BY ACCESSING AND/OR USING THE SOFTWARE, YOU AGREE TO BE BOUND BY THE TERMS OF THIS AGREEMENT. IF YOU DO NOT AGREE TO THE TERMS OF THIS AGREEMENT, DO NOT USE THE SOFTWARE.

Here you will find video tutorials for Centrum Pile Select. The video about Centrum Drawings is in Danish, and the video about Centrum Pile Calculator is in Swedish.

Watch the Swedish Centrum Calculator instruction video

Watch the Danish Centrum Drawings instruction video

Select country

Pile

Special reinforcement

Ends and cast in parts

Generate drawing